Price: $39.95

The new 360 degree mirrors 7 panel system makes it the first mirror ever that allows you to see any part of your head.  When closed you have a mirror with 5x magnification.  Open up the 7 panels and see completely around your entire head or pull the 360 degree arms strait forward and have a double mirror within inches of your face.  No more bending over the sink to see up close.  Perfect for any size bathroom, makes the perfect Christmas or House Warming Gift.

Accessories:

• 3 X AAA Batteries (Not Included)
• 4 Piece Screw Set
• 4 Piece Screw Sheathes
• 4 Piece 2-Sided Mounting Tape

Quick and easy, 3 ways to install.  Folds out to extend over 1 foot, Dual lights at the top and bottom.

(Installation Method One)
To attach the 360-Degree Mirror on a smooth surface with suction cups.

1. Place the 2 suction cups in the mounting back plate base.
   NOTE: DO NOT WET SUCTION CUPS.
2. Place the mounting back plate base on to a smooth surface with arrow pointing upward. Use fingers to depress suction cup stem thus removing all air from beneath the suction cups.
3. Rotate suction cup knobs on to the suction cup threaded stems. Tighten until the mounting back plate base feels secure to the smooth surface.
4. Fasten the 360-Degree Mirror onto the mounting back plate base.

Mirror Dimensions:

• Front and Center Round Mirror - 4 1/4 Inches Diameter
• Square Side Panels - 4 1/2 x 4 1/2
• Mirror In Folded or Closed Position: 6 In. Wide x 9 3/4 Tall x 2 3/4 Deep.

(Installation Method Two)
Permanent Installation using screw assemblies

1. Place the mounting back plate base on the wall in desired position and mark holes for drilling.
2. Drill 4 holes on the marked fastener position points on the wall.
3. Install the screw sheathes in the newly drilled holes in the wall.
4. Place the mounting back plate brace in position over holes.
5. Using screw driver and screws, mount the back plate in to position.
6. Fasten the mirror to the back plate.

(Installation Method Three)
Attach the 360-Degree Mirror to a smooth surface by using adhesive pads.

1. The Suction Cup Back Plate is not needed for this type of installation method.
2. Apply the double face adhesive pads directly on the bottom of the mirror.
3. Adhere the mirror to a smooth surface.

Battery Installation

Using a screw driver, install the 3 x AAA batteries (Not Included) in the back panel battery box.

Precautions:

1. DO NOT WET SUCTION CUPS BEFORE MOUNTING.
2. Please install and use the 360 Degree Mirror according to this Instruction Manual.
3. To avoid the 360 Degree Mirror from coming unattached from mounting surface, please do not apply unnecessary downward force to the product during use.
4. Do not mix new and old, or different types of batteries. Dispose of used batteries according to local environment protection laws and regulations.
5. Please Note: To avoid scratching the 360-Degree Mirror, use a non abrasive polishing cloth for cleaning.
6. Only light pressure is needed when using the polishing cloth to clean the 360-Degree Mirror.